Domain sample allocation within primary sampling units in designing domain-level equal probability selection methods
by Avinash C. Singh and Rachel M. HarterNote 1
- Release date: December 17, 2015
Self-weighting estimation through equal probability selection methods (epsem) is desirable for variance efficiency. Traditionally, the epsem property for (one phase) two stage designs for estimating population-level parameters is realized by using each primary sampling unit (PSU) population count as the measure of size for PSU selection along with equal sample size allocation per PSU under simple random sampling (SRS) of elementary units. However, when self-weighting estimates are desired for parameters corresponding to multiple domains under a pre-specified sample allocation to domains, Folsom, Potter and Williams (1987) showed that a composite measure of size can be used to select PSUs to obtain epsem designs when besides domain-level PSU counts (i.e., distribution of domain population over PSUs), frame-level domain identifiers for elementary units are also assumed to be available. The term depsem-A will be used to denote such (one phase) two stage designs to obtain domain-level epsem estimation. Folsom et al. also considered two phase two stage designs when domain-level PSU counts are unknown, but whole PSU counts are known. For these designs (to be termed depsem-B) with PSUs selected proportional to the usual size measure (i.e., the total PSU count) at the first stage, all elementary units within each selected PSU are first screened for classification into domains in the first phase of data collection before SRS selection at the second stage. Domain-stratified samples are then selected within PSUs with suitably chosen domain sampling rates such that the desired domain sample sizes are achieved and the resulting design is self-weighting. In this paper, we first present a simple justification of composite measures of size for the depsem-A design and of the domain sampling rates for the depsem-B design. Then, for depsem-A and -B designs, we propose generalizations, first to cases where frame-level domain identifiers for elementary units are not available and domain-level PSU counts are only approximately known from alternative sources, and second to cases where PSU size measures are pre-specified based on other practical and desirable considerations of over- and under-sampling of certain domains. We also present a further generalization in the presence of subsampling of elementary units and nonresponse within selected PSUs at the first phase before selecting phase two elementary units from domains within each selected PSU. This final generalization of depsem-B is illustrated for an area sample of housing units.
Key Words: Epsem and depsem designs; Multiple domain estimation; Self-weighting estimation; Two phase two stage designs.
Table of content
- 1. Introduction
- 2. Review of depsem-A designs with a simple justification
- 3. Review of depsem-B designs with a simple justification
- 4. Proposed generalizations of depsem-A/B designs
- 5. Generalizations of depsem-C designs in the presence of subsampling within PSUs and nonresponse at the first phase
- 6. Application of depsem-C2' design to toolbox development
- 7. Summary and concluding remarks
- Date modified: